[. . . ] At present, the "Save-to-Disk" power management feature of this system does not fully function in Windows 98. It is very important that this feature be disabled, particularly if you will be using the FAT32 file system. Instructions for disabling "Save-to-Disk" are in the below section labeled, "Disabling the Save-to-Disk in the BIOS Setup. " Note: To identify your computer's file system format, double click on the My Computer desktop icon. [. . . ] Press the down arrow to select the "Auto Save To File" row entry. Press the plus (`+') to change the "On" setting to "Off. " 7. Highlight "Save Changes and Exit" if it is not already selected. 2 NEC Versa 4200 Windows 98 Upgrade Information 9. Press the Enter key twice to save the settings and reboot the system. Upgrading To Windows 98 Use these steps to upgrade from Windows 95 to Windows 98. If your system has Auto Insert Notification enabled, a Windows 98 graphic appears asking you if you want to upgrade to Windows 98. Use Windows Explorer to navigate to the Windows 98 Setup utility, at the root of the CD-ROM drive. Answer all prompts appropriately. Note: You must to make three key decisions depending on your particular needs and system configuration. Use the following guidelines. T Concerning docking stations: You should perform the Windows 98 upgrade in the mode (docked or undocked) which you use most often. This is purely a decision of convenience, as Windows 98 upgrades docking configurations on an "as detected" basis. Early during the Windows 98 upgrade process you are prompted to decide if you want to back up your Windows 95 system files. Whether or not you backup your Windows 95 system files is a judgement decision that is left entirely to you. Just keep in mind that approximately 50 MB of hard drive space will be consumed by doing so. Early during the Windows 98 upgrade process you are prompted to make a Windows 98 bootable Startup diskette, which loads CD-ROM drivers. If your system cannot run both a floppy drive and a CD-ROM drive at the same time, skip this section by selecting "Cancel" at the "Insert diskette" screen. Later, when you have the floppy drive installed, go to the Control Panel, Add/Remove Programs, select the "Windows Setup" tab, and create a startup diskette. T T Upgrading the NEC Mouse Driver When restarting your NEC Versa computer using the Windows 98 operating system in DOS mode, you may experience system problems. To prevent potential system problems, install this updated version of the NEC Versa mouse (VersaGlide) driver. NEC Versa 4200 Windows 98 Upgrade Information 3 Downloading the VersaGlide Driver Follow these instructions to download the VersaGlide driver. [. . . ] Click Yes to restart your computer and activate the new mouse driver. 4 NEC Versa 4200 Windows 98 Upgrade Information Configuring LapLink for Windows Before using LapLink on your Versa 4200 system using the Windows 98 operating system, you must edit the LapLink. ini file and configure LapLink's Port Setup. Go to Start, Programs, Laplink for Windows, and select Laplink for Windows. If this is the first time that you are configuring Laplink you will receive a dialog box to run port setup. [. . . ]